Subscribe by email

Water level indicator

A very simple low cost water level indicator circuit is presented in this schematic circuit . This water level indicator is based on a simple CMOS IC CD4066 and indicates the amount of water present in the overhead tank and also gives an alarm when the tank is full.
As you can see in the circuit diagram the circuit uses the widely available CD4066, bilateral switch CMOS IC to indicate the water level through LEDs.
When the water is empty the wires in the tank are open circuited and the 180K resistors pulls the switch low hence opening the switch and LEDs are OFF. As the water starts filling up, first the wire in the tank connected to S1 and the + supply are shorted by water. This closes the switch S1 and turns the LED1 ON. As the water continues to fill the tank, the LEDs2 , 3 and 4 light up gradually.

The no. of levels of indication can be increased to 8 if 2 CD4066 ICs are used in a similar fashion.
When the water is full, the base of the transistor BC148 is pulled high by the water and this saturates the transistor, turning the buzzer ON. The SPST switch has to be opened to turn the buzzer OFF.
As you can see this electronic liquid sensor circuit require very few external components and need to be powered from a 6 volts DC power supply .

water level indicator schematic circuit using CMOS IC and LEDs

Comments

Mine Works almost perfect!!! only problem is as S1 S2 S3 S4 begin to close and light the LEDs. S4 does not light up unless directly contacting the POS+ or in VERY close proximity to one another. (this problem exists even when alarm is off or on) when alarm is on the it sounds off but still does not light LED4.

hi, how i can connect this circuit if i want to put a motor that when the tank doesn't full,the motor will rotate in one side and when it becomes full the motor will rotate to another side

Add new comment